Led Indications - ABB ACS880-104 Hardware Manual

200 Maintenance

LED indications

Warnings and faults reported by the control program are displayed on the control panel or
in the Drive composer PC tool. For further information, see the firmware manual of the
inverter control program.
The ACS-AP-x control panel has a status LED. The control panel holder (frames R1i...R4i)
or door mounting kit DPMP-xx has two status LEDs. Frame R8i inverter modules have
three LEDs. The indications of all these LEDs are shown in the table below.
Location
ACS-AP-x control panel
(status LED)
Control panel holder or
door mounting kit
R8i inverter module
LED
Continuous green
Flickering green
Blinking green
Continuous red
Blinking red
Blinking blue
(ACS-AP-W only)
Flickering blue
(ACS-AP-W only)
Red
Green
FAULT
(continuous red)
ENABLE / STO
(continuous green)
ENABLE / STO
(continuous yellow)
POWER OK
(continuous green)
Indication
The inverter unit is functioning normally.
Data is being transferred between the PC and the
module through the USB connection of the control
panel.
There is an active warning in the inverter unit.
There is an active fault in the inverter unit.
There is a fault that requires the stopping and
restarting of the inverter unit.
The Bluetooth interface is enabled, in discoverable
mode, and ready for pairing.
Data is being transferred through the Bluetooth
interface of the control panel.
There is an active fault in the inverter unit.
Power supply of the inverter control unit is OK.
There is an active fault in the module.
The module is ready for use.
XSTO connectors are de-energized.
Supply voltage of the internal circuit boards is OK
(> 21 V).