Changing The Maintenance Information; Hours On; Hours Of Use - Technogym Top 600 XTPRO Service Maintenance Manual

TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0

9.4. CHANGING THE MAINTENANCE INFORMATION

To set the maintenance information at the desired values (for example after replacing the CPU
board), with the equipment in the standby mode, press number keys 314 at the same time. The
following message will appear on the matrix display:
Enter code 2709 (password) and press ENTER to confirm. At this point, the LED matrix will show
the values you can change.
9.4.1. H
OURS ON
To change this value, when the value actually in memory will scroll on the LED matrix:
input the desired value using the numeric keys to enter and press ENTER to confirm. Just press
ENTER to maintain the original value.
9.4.2. H
OURS OF USE
To change this value, when the value actually in memory will scroll on the LED matrix:
input the desired value using the numeric keys to enter and press ENTER to confirm. Just press
ENTER to maintain the original value.
The system will now go back to the standby mode. The "CLEAR" key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.
PASSWORD = 0
HOURS ON = xxx
HOURS OF USE = xxx
Page 9.5