TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0
8.3. CHAIN ALIGNMENT
Figure 8.3-1
Carry out the procedures described in paragraph
7.6. "Disassembling the right and left side
casings".
1. Back off dowel a fixing the primary shaft
with a 5-mm hex T-wrench.
2. Move the primary shaft by the amount
necessary to obtain alignment of the chain.
3. After completing the adjustment, lock down
what previously backed off.
To ensure correct alignment of the
chain, move it back and forth and make
sure that there is no noise.
After completing this procedure, check
the chain tension as described in
paragraph 8.4.
Page 8.3