Enabling The Display Mode; Maintenance Information; Hours On; Hours Of Use - Technogym Top 600 XTPRO Service Maintenance Manual

then press ENTER to confirm the changes made.
9.2.2. E
NABLING THE DISPLAY MODE
It is possible to enable a display mode function which automatically scrolls the data shown on the 7
segment display. To change the setting, when the LED display is showing the current configuration,
press the number keys (from 1 to 2) to enable or disable the scrolling function, as shown in the table
below:
then press ENTER to confirm the choice.
The system will now go back to the standby mode. The "CLEAR" key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.

9.3. MAINTENANCE INFORMATION

In order to perform regular maintenance correctly, the actual number of hours the equipment has
been operated and turned on can be visualized by entering a special access code. With the
equipment in the standby mode, press numeric keys 314 at the same time. The following message
will appear on the matrix display:
Enter code 1508 (password) and press ENTER to confirm. At this point, the LED matrix will scroll
the memorized values of the following information.
9.3.1. H
OURS ON
The number of hours the machine has been turned on:
Press ENTER to go ahead.
9.3.2. H
OURS OF USE
The number of hours the machine has been operating:
Press ENTER to go ahead.
The equipment will now return to the standby mode.
Page 9.4
TOP 600 XTPRO: Service & Maintenance Manual - rev. 2.0
1 OFF = DISABLED
2 ON = ENABLED
K D
EY ISPLAY MODE
1 OFF = DISABLED
2 ON = ENABLED
PASSWORD = 0
HOURS ON = xxx
HOURS OF USE = xxx