Maintenance Information; Hours; Hours Of Use; Changing The Maintenance Information - Technogym BIKE XT Service Maintenance Manual

BIKE XT: Service & Maintenance manual - rev. 2.0

9.2. MAINTENANCE INFORMATION

In order to perform regular maintenance correctly, the actual number of hours the equipment has
been operated and turned on can be visualized by entering a special access code. With the equipment
in the standby mode, press numeric keys 314 at the same time. The following message will appear on
the matrix display:
Enter code 1508 (password) and press ENTER to confirm. At this point, the LED matrix will scroll
the memorized values of the following information.
9.2.1. H
OURS ON
The number of hours the machine has been turned on. Press ENTER to go ahead.
9.2.2. H
OURS OF USE
The number of hours the machine has been operating. Press ENTER to go ahead.
The equipment will now return to the standby mode.

9.3. CHANGING THE MAINTENANCE INFORMATION

To set the maintenance information at the desired values (for example after replacing the CPU
board), with the equipment in the standby mode, press number keys 314 at the same time. The
following message will appear on the matrix display:
Enter code 2709 (password) and press ENTER to confirm. At this point, the LED matrix will show
the values you can change.
9.3.1. H
OURS ON
To change this value, when the value actually in memory will scroll on the LED matrix, input the
desired value using the numeric keys to enter and press ENTER to confirm. Just press ENTER to
maintain the original value.
9.3.2. H
OURS OF USE
To change this value, when the value actually in memory will scroll on the LED matrix, input the
desired value using the numeric keys to enter and press ENTER to confirm. Just press ENTER to
maintain the original value.
The system will now go back to the standby mode. The "CLEAR" key can be pressed at any time to
interrupt the setup procedure and return the equipment to the standby mode.
PASSWORD = 0
PASSWORD = 0
Page 9.3