HPE StoreOnce 3100 Installation And Configuration Manual page 48

Table 10: SNMP Agent configuration parameters
Name
System description
SNMP version
State
Port
Encrypt Passwords and
Communities
System Contact
System Location
Read Community
System Object ID
Engine ID
Allow non-V3 read requests
48 Setting up SNMP (Simple Network Management Protocol)
Description
This is the description for the StoreOnce system configured for
the agent.
This is the SNMP version of the agent (version 1, 2, or 3). The
default is 2.
This shows the state of the agent (off, on).
This is the port location of the agent.
This defines whether encryption for passwords and communities
is on or off.
This is the contact information for the system administrator,
which may be a name, email address, or phone number. A
maximum of 20 characters is allowed.
This is the physical location of the StoreOnce appliance. A
maximum of 20 characters is allowed.
This defines the SNMP Read Community string. The default is
public. If you want to restrict read access, enter a string of up to
20 characters. This string acts as a password for Read access
and must be manually configured in the management
application so that it can access events.
The SNMP agent unique System Object ID. SNMP agents
(running on a StoreOnce Device) supporting HP-
httpManageable-MIB must provide a unique System Object ID.
This ID is used by network management entities to determine
the monitoring capabilities of a device.
This optional device-specific parameter can be provided to an
SNMP version 3 trap listener device such as HP SIM (or any
third party tool) to listen to version 3 traps coming from the
device.
This optional parameter can be provided during version 3
configuration. If the value is yes, versions 1 and 2 are supported
along with version 3. If the value is no, only version 3 is
supported. If this parameter is not configured, only version 3 will
be supported.