ABB S800 I/O Manual page 84

Load the CI801 Software Upgrade
To load the firmware:
1.
2.
3.
4.
5.
6.
Loading the BASE Firmware for CI801 PR: A to E and CI801Z PR: A
The loading of the new firmware takes about 15 minutes.
The following messages are displayed during the download:
•
•
•
To load the firmware:
1.
2.
3.
4.
5.
6.
7.
84
Run the program,
loader32_42-1.exe
Click Next.
Select the COM-Port to use, and enter the path to the image file.
Click Download.
When the download is finished, set the station address back to the used address.
Switch off the power supply and then switch on the power supply, to restart
CI801.
Initialization of target
Load image file
Download finished successful
Run the program,
loader32_42-1.exe
Click Next.
Select the COM-Port to use, and enter the path to the image file.
Disconnect power to CI801 and connect the power again.
Wait for the FCI to start up, and then click Download.
When the download is finished, set the station address back to the used address.
Switch off the power supply and then switch on the power supply, to restart
CI801.
Section 5 Maintenance
.
.
3BSE020926-600