Sanyo POA-WL11 Operation Manual page 61

Setting
You can configure various projector settings.
The values shown next to each parameter are current settings and status.
Parameter
Language Select a preferred language for menu display from the pull-down list, and click
[Set]. Menu will be displayed in the selected language.
Keystone Click
Check [High Speed] box, if you need to increase the variation.
Click [OFF] button, if no Keystone correction is needed.
Blue Back Select [ON] or [OFF] to display/not display blue background when no signal is
detected.
Display Select [ON] or [OFF] to display/not display the screen.
Logo Select [ON] or [OFF] to display/not display the logo at startup.
Ceiling By clicking [ON] button, the image gets reversed vertically and horizontally to
adjust to ceiling-mount projection.
Rear By clicking [ON] button, the image gets reversed horizontally to adjust to rear
projection.
No Show By clicking [ON] button, the image will be temporarily hidden from view.
Freeze By clicking [ON] button, the image will temporarily freeze.
Power Management When no input signal is detected and the projector is idle for approximately 5
minutes and 30 seconds, the lamp will automatically shut off. If the setting is
set to [OFF], the feature is disabled.
On Start By clicking [ON] button, the projector will be automatically turned on when the
power plug is connected to AC outlet.
Remote Control You can change Remote Control codes. When you change Remote Control
code, you must also change the code in the Remote Control unit itself.
Lamp Counter Reset You can reset the lamp counter.
Do not reset unless you are replacing the lamp.
P-TIMER When you click [P-TIMER] button, the timer will appear on the projected
screen. Click again and the elapsed time will appear. Click again and the
timer will disappear.
[NOTE] Since configuration parameters vary depending on the projector model, the contents
mentioned above may be different from the actual configuration. For details, refer to
Owner's Manual of each projector.
Chapter 5.
Description
/ ▲ / ▼ button to correct Keystone distortion.
/
— 61 —
Operating the WI Client