Sanyo POA-WL11 Operation Manual page 15

Notes on using Wireless Imager in factory default state
(LAN 1 ~ LAN 3)
When you use your Wireless Imager unit in factory default state, take following precautions.
● [Using LAN1 with Wireless LAN enabled PC]
The PC must have following settings.
IP address: 169.254.0.1 ~ 169.254.255.254
(This is the range of IP addresses for a PC that needs to establish communication with
Wireless Imager. Select "Obtain an IP address automatically" option in TCP/IP
Properties of Windows 98/Me/2000/XP. If there is no DHCP server in the network, an
IP address in this range will be assigned. However, [169.254.100.100] is the default IP
address for Wireless Imager. Therefore, if there is a PC in the network with the same
IP address, you must restart that PC. With regard to duplicate IP address, consult with
your network administrator.)
Wireless mode: 802.11AdHoc
SSID/ESSID: Use the same SSID/ESSID set to your PC
WEP encryption: Disabled (If WEP is set for your PC, configure WEP settings for Wireless
Imager.)
● [Using LAN2 with Wireless LAN enabled PC]
The PC must have following settings.
IP address: "Obtain IP address automatically"
Wireless mode: Infrastructure
SSID/ESSID: Use the same SSID/ESSID set to the access point in the network.
WEP encryption: Disabled (If WEP is set for your access point, configure WEP settings for
Wireless Imager.)
[NOTE] The default SSID/ESSID for Wireless Imager is set to "ANY". This SSID/ESSID
("ANY") allows communication to the access point in the best link condition.
Therefore, if there are several access points in your area, and you want to establish a
link with an access point in the same network segment, you must have Wireless
Imager in the best possible link condition (for example, locate Wireless Imager as
close to the access point as possible).
To check with which access point your Wireless Imager is communicating, press the
Test Switch on the unit to display its current settings. The SSID/ESSID of access
point to which Wireless Imager is communicating will appear in the parenthesis, "( )",
next to "ANY". However, the SSID/ESSID that is displayed from the projector will be
in uppercase. For the actual spelling of SSID, consult with you network administrator.
To check the IP address that was obtained from DHCP server, press the Test Switch
on the unit to display current settings. The DHCP-assigned IP address will be shown
in "IP Address".
Chapter 1. Overview of Wireless Imager
— 15 —