Sanyo POA-WL11 Operation Manual page 38

Chapter 4. Setting up Wireless Imager
If the contents you have set on this page are correct, click the [APPLY] button.
The screen prompting you to restart Wireless Imager will appear. If no other configuration change is
necessary, click the [RESTART] button to restart Wireless Imager. The changed settings will take effect
upon Restart.
[NOTE] To return the contents you have set to the previous settings, click the [REFRESH] button
before pressing [APPLY] button.
To return the settings to the factory default settings, click the [Restore Factory Default
Settings] button. Only Wireless setup items are then returned to the factory default
settings.
[NOTE] No advanced setup items are provided depending on PCs and access points. If there is
only Enable/Disable setting of WEP, set Wireless Imager as [Enable (40 bit/ open
system)] firstly. If communication cannot be conducted properly, select [Enable (40 bit/
shared key)].
If you can set Enable/Disable and the bit number, set Wireless Imager as [Enable (40 bit/
open system)] or [Enable (128 bit/ open system)] in accordance with the bit number. If it
cannot communicate properly, select [Enable (40bit/ shared key)] or [Enable (128bit/
shared key)] in accordance with the bit number.
If the setting of WEP encryption does not fit to a PC and an access point, Wireless
Imager cannot communicate properly. Return to Factory Default Setting and reset
Wireless Imager.
Four WEP keys can be set, however, the only one with check on the radio button is in
effect. Both of the number and the value of WEP key in effect must be same as the
setting of a PC and an access point.
Depending on PCs and access points, you may be allowed to select only one WEP key.
In this case, use WEP key 1.
— 38 —