Setting Up With The Browser - Sanyo POA-WL11 Operation Manual

Chapter 4. Setting up Wireless Imager

4.3. Setting up with the Browser

Using the Web Browser, Wireless Imager is set in the environmental conditions you are actually using.
You can store three separate network settings (LAN 1 ~ LAN 3) in Wireless Imager. (refer to [1.5 Factory
Default Settings] for more details)
To configure Wireless Imager via a web browser, power ON Wireless Imager firstly, and start up the Web
Browser of the personal computer. Input the IP address set of your Wireless Imager to the address field
of the Browser. (For example, http://169.254.1.100.)
Setup screen (next page) appears. Select setup parameter on browser menu.
[NOTE] Web Browser to be used must be Microsoft Internet Explorer (Ver. 4.0 or later) or Netscape
Communications Netscape Navigator (Ver. 4.6 or later). This manual describes using
Microsoft Internet Explorer (Ver. 6.0).
To display the contents of configuration screen in English, select "English" in menu.
If you change the settings of Wireless Imager by the browser or WI Set while it is
transmitting data in Rear-Time Capture mode, the settings prior to the change may be
shown on the display when you view the setting values from the projector's menu. At this
point, the changed settings are already in effect.
[Disconnect] from Real-Time Capture mode, and view the settings from the projector's menu
again. Then the new settings will be displayed.
NOTE: Make sure that the Web Browser settings are those shown below.
Proxy server is used When using Internet Explorer
Start up Internet Explorer. Select [Tools] > [Internet Options]. Select the
[Connection] tab and click the [LAN Setup] button in the [Local Area
Network (LAN) Setup] field. Check on [Proxy server is not used at local
address] of the [Proxy Server] field.
Or, make the settings as follows.
Start up Internet Explorer. Select [Tools] > [Internet Options]. Select the
[Connection] tab and click the [LAN Setup] button in the [Local Area
Network (LAN) Setup] field. Click the [Details] button in the [Proxy Server]
field. Input the IP address set on the Wireless Imager in the [Proxy server
is not used at address starting from the following IP address] field.
When using Netscape Navigator
Start up Netscape Navigator. Select [Edit] > [Setup] > [Category]. Select
[Details] and [Proxy], and check on [Set proxy manually.]. Click the
[Display] button and input the IP address set on Wireless Imager in the
[Proxy server is not used at address starting from the following IP address]
field.
— 30 —