Sanyo POA-WL11 Operation Manual page 58

Chapter 5. Operating the WI Client
PC Adjustment
This feature optimizes the signal from a connected PC for better quality projection.
[NOTE] [PC] control screen is only displayed when analog computer is selected as the
Parameter
Auto PC Adjustment
Fine Synch
Total Dots
Position
Comment
SYSTEM
You can select a color system for input signal and scan mode.
[NOTE] [SYSTEM] control screen is only displayed when Video is selected as the input
Parameter
Color System Adjustment
(VIDEO, S-VIDEO input only)
System Adjustment
(Y,Pb/Cb,Pr/Cr input only)
[NOTE] Since configuration parameters vary depending on the projector model, the contents
mentioned above may be different from the actual configuration. For details, refer to
Owner's Manual of each projector.
input source.
Click [Start] button to initiate Auto PC Adjustment.
Use / button to adjust tracking.
Use / button to adjust total dot counts for horizontal synch.
/ ▲ / ▼ button to adjust the screen position.
Use /
You can store any comments regarding the PC Adjustment settings. To save
the comments you entered, click [Save] button.
source.
Select a color system for the input signal by clicking the radio button,
and click [Set].
AUTO:
Automatically adjust to the color system of input signal.
PAL, SECAM, NTSC, NTSC4.43, PAL-M, PAL-N:
You can select the color system manually.
Select a scan mode for the input signal by clicking the radio button,
and click [Set].
AUTO:
Automatically adjust to the scan mode of input signal.
1080i, 1035i, 720p, 575p, 480p, 575i, 480i:
You can select the scan mode manually.
— 58 —
Description
Description