Sanyo POA-WL11 Operation Manual page 65

6.2. Setting up the IP address with "arp" + "ping" command
In addition to using WI Set application in the supplied CD-ROM, you can use "arp" and "ping" command
from Command Prompt to assign an IP address to your Wireless Imager.
1. Start up Wireless Imager and configure the wireless LAN card in your PC to communicate with the
Wireless Imager unit.
2. From Windows [Start] menu, click [Run]. In the field next to [Open:], enter "command" and click
[OK]. When "MS-DOS prompt" (or command prompt) appears, type in "arp" command as follows:
(Example)
C:\ > arp -s 169.254.1.100 00-c0-6f-05-1c-c2
Indicates an IP address you wish to assign to your Wireless Imager unit.
Separate MAC address of your Wireless Imager unit every two characters by hyphen.
MAC address is indicated on a label attached to the bottom of each unit.
3. Next, enter "ping" command as follows:
(Example)
C:\ > ping 169.254.1.100
Indicates an IP address you wish to assign to your Wireless Imager unit.
Reply from 169.254.1.100:bytes=32 times=2ms TTL=255
(if this message appears, the IP address was successfully assigned to Wireless Imager)
[NOTE] The assigned IP address is saved in the firmware of Wireless Imager, thus it will remain
set even when the power is off. You can use the same method to re-assign an IP
address.
If [arp+ping] option is disabled in TCP/IP setting of Wireless Imager, you cannot assign an
IP address using "arp" and "ping" commands. (In factory default state, [arp+ping] is set to
"Enable").
(by executing ping command, the IP address will be set)
— 65 —
Chapter 6. Appendix