Sanyo POA-WL11 Operation Manual page 53

(B) Select a desired display color setting, [16 bit] or [24 bit].
● 16 bit
When checking on [16 bit], the colors are transferred at a maximum rate of 16 bits. The
transfer speed becomes faster, compared to 24-bit transfer
● 24 bit
When checking on [24 bit], the colors are transferred at a maximum rate of 24 bits. When the
image type is set at [Photo Mode], the display color is fixed at 24 bits.
[NOTE] The display color of the options setup of WI Client may depend on the display
setting of the personal computer.
Display setting of
personal computer (bit) setup of WI Client (bit)
16
24
32 (*1)
*1: Even though the display setting of the personal computer is set at [32 bit], the number of
colors becomes 16,770,000 colors, the same as 24 bit.
6. Set to Default
When clicking [Set to Default], the current settings (Options, Target, transfer mode (real-time capture
or disconnect)) are saved. When running WI Client next time, it is possible to run it with the same set
values.
For example, if you click [Set to Default] to exit WI Client when your PC is connected to certain
Wireless Imager with the settings : real-time capture, presentation mode and 16 bit, your PC will
connect to the same Wireless Imager with the same image settigs and real-time capture when
restarting WI Client.
7. About WI Client
When clicking [About WI Client], the version information about WI Client will be shown.
8. Help
When clicking [Help], the help about WI Client will be shown.
Chapter 5.
Display color setting of options Display color projected
16
24
16
24
16
24
— 53 —
Operating the WI Client
by projector (bit)
16
16
16
24
16
24