Chapter 5. Operating The Wi Client; Preparing The Client Personal Computer - Sanyo POA-WL11 Operation Manual

Chapter 5.

Chapter 5. Operating the WI Client

This chapter describes how to operate WI Client used to transfer images of the personal computer.
By accessing to Wireless Imager with WI Client application software, you can transmit the image from
your PC screen to a projector, and also remotely operate and configure the projector.
[NOTE] Only one PC can transmit the images to Wireless Imager at a time. Multiple PCs cannot
transmit simultaneously.
This system is not applicable to an application software using DirectX, MS-Office assistant,
and replaying of motion pictures, such as DVD.

5.1. Preparing the client personal computer

Prepare a personal computer used to operate Wireless Imager. Check the following items about the
personal computer.
• Check the hardware specifications of the personal computer. (For details, see [1.3. Operating
environment] in Chapter 1.) If the hardware specifications of the personal computer are
insufficient, Wireless Imager may not be operated at its maximum operating level.
• It is necessary to install a wireless LAN card (adaptor) allowing wireless LAN communication
(applicable to IEEE802.11b) in the personal computer.
However, when using the infrastructure communication (communication through access points),
the communication can also be performed from the wired LAN (Ethernet) side. In this case, the
personal communication needs only the wired LAN (Ethernet) card.
Make sure that the communication can be performed with the contents set in Chapters 4.
• Make sure that the WI Client is installed in the personal computer you wish to use. (For details,
see [3.3. Installing WI Client] in Chapter 3.)
[NOTE] It is not absolutely necessary to install WI Client. You can also run WI Client directly
from the software CD-ROM. (For details, see [3.4. Starting up WI Client] in Chapter 3.)
Operating the WI Client
— 48 —