Sanyo POA-WL11 Operation Manual page 28

Chapter 4. Setting up Wireless Imager
6. The main menu screen will appear.
7. Click the [Launch the IP address setup tool] icon.
The IP address setup tool (WI Set) will be started up.
8. Click on WI Set pull-down list (▼). The MAC address of Wireless Imager you can set will be
shown in the list. Select the MAC address of Wireless Imager you wish to set the TCP/IP, and
then click the [OK] button.
[NOTE] If the list is not displayed on this screen, the wireless communication conditions for
the personal computer may be set incorrectly. Check the settings again with referring
to [4.1.1. Setting the personal computer (with wireless LAN card applicable to "802.11
AdHoc" mode)] or [4.1.2. Setting the personal computer (with wireless LAN card
applicable to "Pseudo AdHoc" mode only)].
[CAUTION] WI Set may not be able to detect Wireless Imager, if the firewall feature in some
✻ The MAC address on this figure is different from the actual address.
PC virus detection program is running. When you use WI Set, disable the firewall
feature temporarily.
— 28 —