Quick Setup - Sanyo POA-WL11 Operation Manual

4.3.2. Quick setup

On the quick setup screen, minimally required setup items necessary for operation are picked up to allow
easy setup.
[NOTE] The contents of this page is a part of the advanced setup page. Therefore, the contents set
on this page may affect relevant items on the advanced setup. If you set the items on the
advanced setup page, the settings on this page are not necessary.
Parameter
Location
IP Configuration Method
IP Address
Subnet Mask
When using multiple Wireless Imager units, a desired installation place
name can be set to distinguish the Wireless Imager from others. The
installation place name set in this field is displayed with it identified on the
[Connect...] menu of the WI Client.
A desired IP address setup method is selected from [Manual], [DHCP],
and [BOOTP].
If [DHCP] or [BOOTP] is selected, the IP address is obtained automatically
as [DHCP client] or [BOOTP client]. At this time, it is absolutely necessary
that the DHCP server/BOOTP server must be in the environment allowing
the network communication.
[NOTE] When the IP Address Configuration Method is set to DHCP or BOOTP, and you
press the test switch to display the settings while Wireless Imager is attempting to
obtain an IP address, IP Address, Subnet Mask, and Gateway Address fields will
display [-.-.-.-].
Likewise, if you attempt to display the current settings on the projector's menu
while Wireless Imager is attempting to obtain an IP address, the existing values of
IP address, Subnet Mask, and Gateway Address will be shown. Once the IP
address is obtained from DHCP server, the menu screen will display the obtained
IP address.
If Wireless Imager fails to obtain IP address from DHCP server or BOOTP server,
the existing IP address will be assigned.
Set the IP address in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting is
not needed.
Set the Subnet mask in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting may
become unnecessary depending on the settings of [DHCP Server] and
[BOOTP Server].
— 33 —
Chapter 4. Setting up Wireless Imager
Description