Information - Sanyo POA-WL11 Operation Manual

Proxy server is not
used

4.3.1. Information

On the initial screen, the setup contents and current status of Wireless Imager are displayed as
information.
When clicking the [REFRESH] button, the display contents are updated.
Parameter
Firmware Version
Boot ROM Version
Hardware Address
Wireless Card Type
IP Address
Wireless Link Status
WEP Security
Current SSID/ESSID
Current Channel
When using Internet Explorer
Start up Internet Explorer. Select [Tools] > [Internet Options]. Select the
[Connection] tab and click the [LAN Setup] button in the [Local Area
Network (LAN) Setup] field. Check off [Proxy server is used at local
address] of the [Proxy Server] field.
When using Netscape Navigator
Start up Netscape Navigator. Select [Edit] > [Setup] > [Category]. Select
[Details] and [Proxy], and check on [Connect Internet directly.].
Shows the firmware version of this system.
Shows the boot ROM version of this system.
Shows the hardware address (MAC address) of this system.
Shows the countries in which the device can be used.
This unit is set to "FCC/IC" or "ETSI" and cannot be changed.
Shows the IP address currently set on this system. If DHCP is set, the IP
address assigned from the DHCP server is displayed.
Shows the wireless communication mode and its status of this system.
Shows the WEP (Encryption) setting status.
However, the WEP key is not shown.
Shows SSID set on this system.
Shows the channel, through which this system is currently communicating.
— 31 —
Chapter 4. Setting up Wireless Imager
Description