Sanyo POA-WL11 Operation Manual page 13

6. Connector plug: Plugs into the projector's connector.
7. DIP switch: DIP switch 1 toggles between Pseudo Adhoc and 802.11 Adhoc mode.
DIP switch 2 is not used. The factory default mode is 802.11 Adhoc mode.
ON
OFF
(DIP switch 1 in OFF position)
[NOTE] When the communication mode is set in the infrastructure mode, the DIP switch setting
does not affect the communication (regardless of positions).
8. Test Switch: This switch is used to check various settings for Wireless Imager.
When this TEST switch is pressed at for 1 second while Wireless Imager is operating,
the projector projects Wireless Imager's settings for approximately 10 sec.
(Press the TEST switch with a sharpened tool.)
(Example Projection contents of factory default settings)
WIRELESS IMAGER INFORMATION:
MAIN PROGRAM:
BOOT PROGRAM:
HARDWARE:
CARD TYPE:
MAC ADDRESS:
CONFIGURATION #:
IP ADDRESS:
SUBNET MASK:
GATEWAY ADDRESS:
IP CONFIGURATION:
ARP + PING:
WIRELESS MODE:
WIRELESS CHANNEL:
WIRELESS SSID/ESSID: WIRELESS
WIRELESS WEP:
VGA REFRESH RATE:
SVGA REFRESH RATE: 60.317 HZ
XGA REFRESH RATE:
[NOTE] Even if the SSID/ESSID is set in lower-case characters, only upper-case characters are
projected. The set values of SSID/ESSID are checked by using the Browser or by viewing
the projector's menu.
Additionally, it is also possible to reset the settings to the factory default settings by using this
TEST switch. To reset to the factory default settings, refer to [To reset Wireless Imager to the
factory default settings] in the [1.5. Factory default settings].
Chapter 1.
1 2
SWITH
KNOB
O F F
802.11AdHoc
VX.XX(XXXX/XX/XX)
VX.XX(XXXX/XX/XX)
XXXX
FCC/IC (1-11) or ETSI (1-13)
00C06FXXXXXX
LAN1
169.254.100.100
255.255.0.0
255.255.255.255
MANUAL
ENABLE
802.11 ADHOC
11
DISABLE
59.879 HZ
60.004 HZ
— 13 —
Overview of Wireless Imager
1 2
Not used
O F F
Pseudo AdHoc
(DIP switch 1 in ON position)
Test Switch