Cisco ONS 15310-MA Troubleshooting Manual page 64

Alarm Procedures
Clear the FORCED-REQ-SPAN Condition
Complete the
Step 1
page
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/cisco/web/support/index.html for more information or call Cisco TAC
(1-800-553-2447).
2.7.79 FP-LINK-LOSS
The FP-LINK-LOSS alarm is not used in the Cisco ONS 15310 platforms in this release. It is reserved
for development.
2.7.80 FRCDSWTOINT
The Force Switch to Internal Timing condition occurs when the user issues a Force command to switch
to an internal timing source.
Note FRCDSWTOINT is an informational condition. It does not require troubleshooting.
2.7.81 FRCDSWTOPRI
The Force Switch to Primary Timing Source condition occurs when the user issues a Force command to
switch to the primary timing source.
Note FRCDSWTOPRI is an informational condition. It does not require troubleshooting.
2.7.82 FRCDSWTOSEC
The Force Switch to Second Timing Source condition occurs when the user issues a Force command to
switch to a second timing source.
FRCDSWTOSEC is an informational condition. It does not require troubleshooting.
Note
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.0
2-64
"Clear an External Switching Command on a Path Protection Span" procedure on
2-151.
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Object: NE-SREF
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Objects: EXT-SREF, NE-SREF
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Objects: EXT-SREF, NE-SREF
Chapter 2 Alarm Troubleshooting
78-18663-01