Cisco ONS 15310-MA Troubleshooting Manual page 61

Chapter 2 Alarm Troubleshooting
2.7.70 FE-IDLE
The Far End Idle condition occurs when a far-end node detects an idle far-end 15310-MA SDH CTX,
E1-21/DS3-E3-3, or E1-63/DS3-E3-3 card DS-3 signal in C-bit line type mode.
Clear the FE-IDLE Condition
To troubleshoot the FE condition, determine which node and port link directly to the card reporting the
Step 1
FE condition.
Log into the node that links directly to the port reporting the FE condition.
Step 2
Clear the main alarm by clearing the protection switch. See the
Step 3
Initiation, and Clearing" section on page 2-146
If the condition does not clear, log into the Technical Support Website at
Step 4
http://www.cisco.com/cisco/web/support/index.html for more information or call Cisco TAC
(1-800-553-2447).
2.7.71 FE-LOCKOUTOFPR-SPAN
The FE-LOCKOUTOFPR-SPAN condition is not used in the ONS 15310 platforms in this release. It is
reserved for development.
2.7.72 FE-LOF
The Far End LOF condition occurs when a far-end node reports the
C-bit line type mode.
Clear the FE-LOF Condition
To troubleshoot an FE condition, determine which node and port link directly to the card reporting the
Step 1
FE condition.
Step 2 Log into the node that links directly to the port reporting the FE condition.
Step 3 Complete the
If the condition does not clear, log into the Technical Support Website at
Step 4
http://www.cisco.com/cisco/web/support/index.html for more information or call Cisco TAC
(1-800-553-2447).
78-18663-01
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Object: DS3
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SDH Logical Object: DS3
"Clear the LOF (E1) Alarm" procedure on page
"2.9.1 Protection Switching, Lock
for commonly used traffic-switching procedures.
"LOF (DS3)" alarm on page 2-86
2-86. It also applies to FE-LOF.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.0
Alarm Procedures
in
2-61