Cisco ONS 15310-MA Troubleshooting Manual page 15

Chapter 2 Alarm Troubleshooting
Table 2-8 ONS 15310-MA SDH Alarm List by Logical Object as Shown in Alarm Profile (continued)
EQPT: HITEMP (MN)
EQPT: IMPROPRMVL (CR)
EQPT: INHSWPR (NA)
EQPT: INHSWWKG (NA)
EQPT: IOSCFGCOPY (NA)
EQPT: MANRESET (NA)
EQPT: MATECLK (MN)
EQPT: MEA (CR)
EQPT: MEM-GONE (MJ)
EQPT: MEM-LOW (MN)
EQPT: NO-CONFIG (NA)
EQPT: OPEN-SLOT (NA)
EQPT: PROTNA (MN)
EQPT: PWR-FAIL-A (MN)
2.5 Trouble Notifications
The ONS 15310-MA SDH systems report trouble by utilizing standard alarm and condition
characteristics, standard severities following the rules in Telcordia GR-253-CORE, and graphical user
interface (GUI) state indicators. These notifications are described in the following sections.
The ONS 15310-MA SDH use standard Telcordia categories to characterize levels of trouble. The
system reports trouble notifications as alarms and status or descriptive notifications (if configured to do
so) as conditions in the CTC Alarms window. Alarms typically signify a problem that the user needs to
remedy, such as a loss of signal. Conditions do not necessarily require troubleshooting.
2.5.1 Alarm Characteristics
The ONS 15310-MA SDH use standard alarm entities to identify what is causing trouble. All alarms
stem from hardware, software, environment, or operator-originated problems whether or not they affect
service. Current alarms for the network, CTC session, node, or card are listed in the Alarms tab. (In
addition, cleared alarms are found in the History tab.)
2.5.2 Condition Characteristics
Conditions include any problem detected on an ONS 15310-MA SDH shelf. They can include standing
or transient notifications. A snapshot of all current raised, standing conditions on the network, node, or
card can be retrieved in the CTC Conditions window or using TL1's set of RTRV-COND commands. (In
addition, some but not all cleared conditions are found in the History tab.)
For a comprehensive list of all conditions, refer to the Cisco SDH TL1 Command Guide. For more
information about transient conditions, see
78-18663-01
STM: LO-RXPOWER (MN)
STM: LOS (CR)
STM: LO-TXPOWER (MN)
STM: LPBKFACILITY (NA)
STM: LPBKTERMINAL (NA)
STM: MANUAL-REQ-SPAN (NA)
STM: PRC-DUPID (MJ)
STM: MS-RFI (NR)
STM: SD-L (NA)
STM: MS-EXC (NA)
STM: SSM-DUS (NA)
STM: SSM-FAIL (MN)
STM: SSM-LNC (NA)
STM: SSM-OFF (NA)
Chapter 3, "Transient Conditions."
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.0
Trouble Notifications
VCTRM-LP: LOM (MJ)
VCTRM-LP: TU-LOP (MJ)
VCTRM-LP: OOU-TPT (NA)
VCTRM-LP: HP-PLM (MJ)
VCTRM-LP: LP-RFI (NR)
VCTRM-LP: ROLL (NA)
VCTRM-LP: ROLL-PEND (NA)
VCTRM-LP: LP-DEG (NA)
VCTRM-LP: LP-EXC (NA)
VCTRM-LP: SQM (MJ)
VCTRM-LP: LP-TIM (MJ)
VCTRM-LP: LP-UNEQ (MJ)
—
—
2-15