International/North American Default Parameter Settings; Parameter Menu Structure - Danfoss VLT FC 102 User Manual

Appendix
Conventions
Numbered lists show procedures.
Bullet lists show additional information.
Italicized text shows cross-references, links, and parameters.
All measurements are presented as metric units (imperial units).

8.2 International/North American Default Parameter Settings

Setting parameter 0-03 Regional Settings to [0] International or [1] North America changes the default settings for some
parameters. Table 8.2 lists those parameters that are affected. Changes made to the default settings are stored. They are
available for viewing in the quick menu, along with any programming entered into the parameters.
Parameter
Parameter 0-03 Regional Settings
Parameter 0-71 Date Format
Parameter 0-72 Time Format
Parameter 1-20 Motor Power [kW]
Parameter 1-21 Motor Power [HP]
Parameter 1-22 Motor Voltage
Parameter 1-23 Motor Frequency
8 8
Parameter 3-03 Maximum Reference
Parameter 3-04 Reference Function
Parameter 4-13 Motor Speed High Limit [RPM]
Parameter 4-14 Motor Speed High Limit [Hz]
Parameter 4-19 Max Output Frequency
Parameter 4-53 Warning Speed High
Parameter 5-12 Terminal 27 Digital Input
Parameter 5-40 Function Relay
Parameter 6-15 Terminal 53 High Ref./Feedb.
Value
Parameter 6-50 Terminal 42 Output
Parameter 14-20 Reset Mode
Parameter 22-85 Speed at Design Point [RPM]
Parameter 22-86 Speed at Design Point [Hz]
Parameter 24-04 Fire Mode Max Reference
Table 8.2 International/North American Default Parameter Settings
1) Parameter 1-20 Motor Power [kW] is visible only when parameter 0-03 Regional Settings is set to [0] International.
2) Parameter 1-21 Motor Power [HP]is visible only when parameter 0-03 Regional Settings is set to [1] North America.
3) This parameter is visible only when parameter 0-02 Motor Speed Unit is set to [0] RPM.
4) This parameter is visible only when parameter 0-02 Motor Speed Unit is set to [1] Hz.

8.3 Parameter Menu Structure

Certain parameters are specific to the drive system. For a list of these parameters and all other system parameters, including
descriptions, refer to the programming guide applicable to the series of drive modules used in creating the drive system.
72
®
VLT Parallel Drive Modules
International Default Parameter Value
International
DD-MM-YYYY
24 h
1)
See Note
2)
See Note
230 V/400 V/575 V
50 Hz
50 Hz
Sum
1500 RPM
3)
4) 50 Hz
100 Hz
1500 RPM
Coast inverse
Alarm
50
Speed 0–HighLim
Manual reset
1500 RPM
3)
50 Hz
50 Hz
Danfoss A/S © 08/2017 All rights reserved.
North American Default Parameter Value
North America
MM/DD/YYYY
12 h
1)
See Note
2)
See Note
208 V/460 V/575 V
60 Hz
60 Hz
External/Preset
1800 RPM
60 Hz
120 Hz
1800 RPM
External interlock
No alarm
60
Speed 4–20 mA
Infinite auto reset
1800 RPM
60 Hz
60 Hz
MG37L202