Introduction
1
1
1 Introduction
1.1 Purpose of the Manual
This manual provides detailed information for startup and
commissioning of the drive system composed of VLT
Parallel Drive Modules. Chapter 4 Commissioning provides
detailed procedures for basic programming, pre-startup
testing, and startup.
The remaining chapters provide supplementary details,
including:
•
The user interface.
•
Detailed programming.
•
Application examples.
•
Operational troubleshooting.
•
Specifications.
This user guide is intended for use by qualified personnel.
To operate and maintain the drive system safely and
professionally, read and follow the user guide. Pay
particular attention to the safety instructions and general
warnings. Always keep this user guide with the drive
system.
®
VLT
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand the functions
and programming of the VLT
•
The VLT
Design Guide contains detailed information about
the capabilities and functionality of motor control
systems using these drive modules, and provides
guidance for designing this type of system.
•
The VLT
Installation Guide provides instructions for
mechanical and electrical installation of these
drive modules.
•
Refer to the FC 102, FC 202, or FC 302 VLT
Programming Guide applicable to the particular
series of VLT
creating the drive system. The programming
guide describes in greater detail how to work
with parameters and provides application
examples.
•
The VLT
contains detailed service information, including
information applicable to the VLT
Modules.
4
VLT
®
Parallel Drive Modules.
®
Parallel Drive Modules 250–1200 kW
®
Parallel Drive Modules 250–1200 kW
®
Parallel Drive Modules used in
®
FC Series, D-frame Service Manual
®
Parallel Drive
Danfoss A/S © 08/2017 All rights reserved.
®
Parallel Drive Modules
•
The VLT
lation Instructions contain detailed information
about installing the DC fuses.
®
•
The VLT
lation Instructions contain detailed information
about installing the busbar option kit.
•
The VLT
lation Instructions contain detailed information
about installing the duct option kit.
Refer to other supplemental publications and manuals,
available from Danfoss. See vlt-drives.danfoss.com/support/
technical-documentation/ for listings.
1.3 Manual and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the manual version and the corresponding software
version.
Manual
version
MG37L2xx
Table 1.1 Manual and Software Version
1.4 Approvals and Certifications
Table 1.2 Approvals
1.5 Disposal
®
Drive
®
Parallel Drive Modules DC Fuses Instal-
®
Parallel Drive Modules Bus Bar Kit Instal-
®
Parallel Drive Modules Duct Kit Instal-
Remarks
Software version
Update to Drive
FC 102 (5.0x), FC 202 (3.0x),
System section
FC 302 (7.6x)
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
MG37L202