Commissioning; Configuring The Et 200Pro Ethernet/Ip Module; Setting The Ip Address - Siemens SIMATIC ET 200pro Manual

Commissioning

5.1

Configuring the ET 200pro EtherNet/IP module

Use the EIP ET200 Configuration Tool to configure the ET 200pro EtherNet/IP module.
Refer to the "EIP ET200 Configuration Tool User Reference Guide" for complete
instructions.
5.2

Setting the IP address

DHCP is the factory default. When the ET 200pro EtherNet/IP module is using DHCP, you
can set IP addresses by using Microsoft Windows and Linux DHCP/BOOTP servers. There
are several free servers for Microsoft Windows available for download from the Internet. Use
discretion when downloading software from the Internet.
After you set the IP address with DHCP, you can then use the EIP ET200 Configuration Tool
to set a permanent IP address and turn off DHCP. See the "EIP ET200 Configuration Tool
User Reference Guide" for detailed instructions.
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
5
53