Preface
Trademarks
This manual references technologies whose names are trademarked by ODVA, the Open
DeviceNet Vendors Association. The ODVA technologies referenced in this manual include:
EtherNet/IP™
CIP™ (Common Industrial Protocol)
QuickConnect™
For more information on ODVA and its trademarked technologies, visit the ODVA website
(http://www.odva.org).
Purpose of the manual
The information in this manual is intended to enable you to operate the ET 200pro
EtherNet/IP interface module on EtherNet/IP.
Required level of knowledge
You require knowledge of the automation engineering field in order to use the material in this
manual.
Scope of the manual
This manual is valid for the ET 200pro EtherNet/IP module. Appendix A provides order
information.
This manual contains a description of the components that were valid at the time the manual
was published. Information about new components and new versions of components is
released in Product Information bulletins available on the Siemens Industry Online Support
(https://support.industry.siemens.com/cs/?lc=en-US) website.
Certifications, Marks, and Standards
The ET 200pro EtherNet/IP module complies with EtherNet/IP Specification CIP Networks
Library Volume 2: EtherNet/IP Adaption of CIP, Edition 1.16.
See the "General technical specifications" chapter for a full description of all applicable
certifications, marks, and standards.
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
1
5