Cleaning And Care - Silvercrest SBB 850 B2 Operating Instructions Manual

Cleaning and care

DANGER! ELECTRIC SHOCK!
► Before cleaning the appliance, always remove
the plug from the socket and allow the appli-
ance to cool down completely.
Protect the appliance from moisture, as this can
lead to electric shock. Please also observe the
safety instructions.
CAUTION! MATERIAL DAMAGE!
► The appliance and its accessories are not
dishwasher-proof!
► Do not use any chemical cleaning agents or
solvents to clean the bread maker.
Housing, lid, baking chamber
■ Remove all residues from the inside of the
baking chamber using a wet cloth or a slightly
damp soft sponge.
■ Wipe both the housing and the lid also only
with a moist cloth or sponge.
For easier cleaning, the appliance lid
removed from the housing:
–
Open the appliance lid
pegs fit through the openings of the hinge
guides.
–
Pull the appliance lid
guides.
■ 14 │ GB │ IE │ NI │ CY
can be
until the plastic
out of the hinge
■ To replace the appliance lid
guide the plastic locking tabs through the opening
of the hinge guides.
■ Dry everything thoroughly and make sure that
all parts are dry before reuse.
Baking mould, kneading blades and
accessories
CAUTION! MATERIAL DAMAGE!
► Never immerse the baking mould
or other liquids.
► The surfaces of the baking mould
kneading blades
coating. When cleaning the appliance, do
not use aggressive detergents, abrasive cleaning
agents or objects that may cause scratches to
the surfaces.
NOTE
► Due to moisture and vapours, the surfaces of
various parts may change in their appear-
ance over the course of time. This has no
influence on the function nor does it reduce
the quality of the baking results.
■ Before cleaning, remove the baking mould
and the kneading blades
chamber.
■ Remove the kneading blades
ing mould . If the kneading blades
be removed from the baking mould
baking mould with hot water for around
30 minutes. The kneading blades
now be easy to remove.
Clean the kneading blades
with mild dishwashing detergent. For stubborn in-
crustations, you can leave the kneading blades
in the washing water until the incrustations can
be removed by means of a dishwashing brush.
If the mounting holes in the kneading hooks
are blocked, these can be carefully cleaned with
a wooden toothpick or similar.
Dry the kneading blades
cleaning.
after cleaning,
in water
and the
are coated with a non-stick
from the baking
from the bak-
cannot
, fill the
should
in warm water
thoroughly after
SBB 850 B2