Error Messages; Cleaning And Care - Silvercrest 73485 Operating Instructions Manual

If the bread does not slip off the kneading paddles
, carefully remove the kneading paddles
using the supplied kneading paddle remover
Note:
Do not use any metal objects which may cause
scratches on the non-stick coating.
After removing the bread, immediately rinse the
baking mould with warm water. This prevents
the kneading paddles
driving shaft.
Tip: If you remove the kneading paddles
the last kneading of the dough, the bread will
remain intact when you remove it from the
baking mould .
• Briefly press the Start/Stop button
the programme at the very start of the baking
phase or, remove the power plug from the wall
socket. Ensure that you re-insert the power plug
within 10 minutes so that the baking process can
be continued.
• Open the appliance lid
baking mould
with floured hands and remove the kneading
paddles .
• Lay the dough back into the baking mould
Replace the baking mould
appliance lid .
• Insert the power plug into the wall socket. The
baking programme continues from where it
was stopped.
Allow the bread to cool for 15-30 minutes before
eating it.
Before cutting the bread, ensure that the kneading
paddles have been removed
from sticking to the
to interrupt
and remove the
. You can take the dough out
and close the
.

Error Messages

. • If the display
has been started, it indicates that the temperatu-
re in the Bread Baking Machine is still too high.
Stop the programme and remove the power plug.
Open the appliance lid
to cool down for 20 minutes before re-using it.
• If a new Programme cannot be started directly
after the Bread Baking Machine has completed
a baking process, it means the appliance is still
too hot. In this case the display panel reverts to
after the default setting (Programme 1). Open the ap-
pliance lid
down for 20 minutes before re-using it.
Warning!
Do not attempt to take the appliance into use before
it has cooled itself down. This functions only with
Programmme 12.
• If the display shows "EE0", "EE1" or "LLL" after
the programme has been started, first of all
switch the Bread Baking Machine off and then
back on by removing and then re-inserting the
power plug from/into the wall socket. Should the
error display continue, make contact with
. Customer Services.

Cleaning and Care

Warning!
Before cleaning it, always remove the power plug
from the wall socket and allow the appliance to
cool down completely.
Protect the appliance against moisture, this could
cause you to receive an electric shock.
Please also observe the safety instructions.
- 11 -
shows "HHH" after the programme
and allow the machine
and allow the machine to cool