Function Block: End-User General; Operating Lines; Scheduler Program 2; Time Of Day And Date - Siemens RVP360 Basic Documentation

28/106
Siemens
Building Technologies
7

Function block: End-user general

This function block provides settings that the end-user himself can make, plus
indication of faults.
7.1

Operating lines

Line Function, parameter
Weekday, for entering scheduler program 2
31
Start of 1st ON phase
32
End of 1st ON phase
33
34 Start of 2nd ON phase
End of 2nd ON phase
35
Start of 3rd ON phase
36
End of 3rd ON phase
37
38 Time of day
Weekday
39
40 Date
41 Year
Faults
50
7.2

Scheduler program 2

Scheduler program 2 can be used for one or several of the following functions:
As a scheduler program for the circulating pump
As a scheduler program for the release of d.h.w. heating
Scheduler program 2 of the controller allows up to 3 ON phases per day; also,
every weekday can have different ON phases.
As with the heating program, it is not the switching times that are to be entered, but
the periods of time during which the program or the controlled function shall be
active.
Using setting "1-7" on operating line 31, a scheduler program that applies to all
weekdays can be entered. This simplifies the settings. If weekend times differ, first
enter the times for the entire week, then change days 6 and 7 as required.
The entries are sorted and overlapping ON phases are combined.
7.3

Time of day and date

The RVP360 has a yearly clock for entering the time of day, the weekday and the
date.
The weekday on operating line 39 is automatically determined according to the set
date and cannot be changed.
The change from summertime to wintertime, and vice versa, is made automatically.
Should the respective regulations change, the changeover dates can be adjusted
(refer to chapter 17 "Function block: Service functions and general settings").
Basic Documentation RVP360
7 Function block: End-user general
Factory setting (range) Unit
1-7 (1...7, 1-7)
05:00 (--:-- / 00:00...24:00) hh:mm
22:00 (--:-- / 00:00...24:00) hh:mm
--:-- (--:-- / 00:00...24:00) hh:mm
--:-- (--:-- / 00:00...24:00) hh:mm
--:-- (--:-- / 00:00...24:00) hh:mm
--:-- (--:-- / 00:00...24:00) hh:mm
(00:00...23:59) hh:mm
Display function
(01.01. ... 31.12.) dd:mm
(2009...2099) yyyy
Display function
Heating
circuit
–
–
–
–
–
–
–
–
–
–
–
–
CE1P2546en
2017-07-24