Siemens RVP360 Basic Documentation page 92

Impact of the individual
QAW70 operating lines
on the controller
92/106
Siemens
Building Technologies
If 1 (slave without remote control) is entered on the controller's operating line 178
("Source of time of day"), the time of day on the QAW70 cannot be readjusted.
Op. line Function, parameter
QAW70
1 Setpoint for NORMAL heat-
ing
2 Setpoint for REDUCED
heating
3 D.h.w. temperature setpoint Changes controller operating line 26 with
4 Weekday (entry of heating
program)
5 1. 1st heating phase, start
of NORMAL heating
6 1. 1st heating phase, end
of NORMAL heating
7 2. 2nd heating phase, start
of NORMAL heating
8 2. 2nd heating phase, end
of NORMAL heating
9 3. 3rd heating phase, start
of NORMAL heating
10 3. 3rd heating phase, end
of NORMAL heating
11 Display of weekdays 1...7
12 Entry of time of day
13 Display of d.h.w. tempera-
ture
14 Display of boiler tempera-
ture
15 Display of flow temperature
16 Holidays
17 Reset to default values
Bus address
51
52 Identification of room unit
53 Operating lock on QAW70
58 Type of setpoint display
Basic Documentation RVP360
20 Communication
Impact on controller, notes
Changes controller operating line 1
Changes controller operating line 2
plant types providing d.h.w. heating
Corresponds to controller operating line 4
Changes controller operating line 5
Changes controller operating line 6
Changes controller operating line 7
Changes controller operating line 8
Changes controller operating line 9
Changes controller operating line 10
Cannot be changed (refer to chapter 7.3
"Time of day and date")
Changes controller operating line 38
Only with plant types providing d.h.w.
heating
(Only with plant types 5 - x and 6 - x)
Controller switches to protection mode
QAW70 default entries apply
For heating circuit 1, address 1 must
be entered
For heating circuit 2, address 2 must
be entered
No impact on the controller
No impact on the controller
CE1P2546en
2017-07-24