Siemens RVP360 Basic Documentation page 96

Knobs for room tem-
perature readjustments
Buttons and displays
for manual control
Display of positioning
commands
Operating line principle
Buttons
Block skip function
96/106
Siemens
Building Technologies
A knob is available for each heating circuit to make manual room temperature
readjustments. Their scales show the room temperature change in °C. When
turning the knob, the heating curve is displaced parallel.
3 buttons are provided for manual control:
1 button for activating manual control. An LED indicates when manual control is
active. Manual control is quit by pressing the same button again or by pressing
any of the operating mode buttons
2 buttons for manual positioning commands. In plants with mixing valves or
2-port valves, the regulating unit in the selected heating circuit can be driven
to any position by pressing the respective button.
When pressing a button, the respective LED lights up
All positioning commands sent to the relays appear on the LCD.
Input and readjustment of all setting parameters, activation of functions and read-
ing of actual values and operating states are based on the operating line principle.
An operating line with an associated number is assigned to each parameter, each
actual value and each function.
A pair of buttons is used to select operating lines and readjust displays.
To select and readjust setting values, the procedure is as follows:
Buttons
Line selection buttons
Setting buttons
The set value is adopted ...
when selecting the next operating line,
by pressing any of the operating mode buttons.
If input of --.- or --:-- is required, button
display appears. Then, the display maintains --.- or --:--.
The operating lines are combined in the form of blocks. To reach a specific operat-
ing line of a function block quickly, the other blocks can be skipped, so that it is not
necessary to go through all the other lines. This is made possible by using 2 button
combinations:
Action
Keep depressed and press
Keep depressed and press
Basic Documentation RVP360
21 Handling
Action Effect
Press Selection of next lower operating line
Press Selection of next higher operating line
Decrease of displayed value
Press
Increase of displayed value
Press
or
Effect
Selection of next higher function block
Selection of next lower function block
must be pressed until the required
CE1P2546en
2017-07-24