Emptying The Recovery Tank; Cleaning The Recovery Tank; Cleaning The Air Intake Filter - HAKO Scrubmaster B100R Instruction Manual

Maintenance and Service

5.6.1 Emptying the recovery tank

Empty the recovery tank (Fig. 12/1) ev-
ery day or as necessary.
1. Drive to an appropriate disposal
point.
2. Park the vehicle so that the draining
hose (Fig. 12/2) reaches the drain in
the floor.
3. Switch off the vehicle.
Observe the applicable laws
and local regulations when dis-
posing of cleaning agents!
4. Remove the draining hose from the
holder, open the lock (Fig. 12/3) and
empty the recovery tank completely.
42

5.6.2 Cleaning the recovery tank

Clean the recovery tank (Fig. 12/1) ev-
ery day or as necessary.
1. Drain off the recovery tank, see
paragraph 5.6.1.
2. Open the tank cap (Fig. 12/4) on the
recovery tank.
3. Open the flap (Fig. 12/5), loosen the
wing nuts on the plugs (Fig. 12/6) a
little and remove the plugs.
4. Open the locks (Fig. 12/7) on the re-
covery tank and pivot the recovery
tank to the rear.
5. Flush out the remaining dirt with
fresh water.
6. Also flush the draining hose.

5.6.3 Cleaning the air intake filter

Check the function of the air intake filter
(Fig. 12/8) and clean it as necessary.
The air intake filter can be accessed
over the tank cap and it can be pulled
from the nozzles.