Table of Contents
Advertisement
Maintenance and Service
5.4.1 Charging batteries
The batteries (Fig. 10/1) are charged
using an appropriate battery charging
device. The charger is connected via
the battery plug (Fig. 10/2). We recom-
mend charging the battery when at
least one LED on the total discharge
signal transducer display (Fig. 10/3)
has gone out after operating the vehi-
cle. Pay attention to the information in
the operating manuals supplied with the
88-60-2723 charger and the battery
manufacturer.
Before starting the vehicle up
for the first time, the batteries
to be used must be fully
charged, properly, by imple-
menting the initial battery
charge routine. Hako assumes
no liability for damage to the
battery caused by a fault when
the battery is charged for the
first time.
Ensure sufficient ventilation in
the charging area when charg-
ing the batteries. – Risk of ex-
plosion.
5.4.2 Low discharge signal indica-
tor (LDS)
The machine is equipped with a charge
indicator to preclude the batteries from
low discharge. This low discharge sig-
nal indicator (Fig. 10/3) is integrated in
the electronics. If other batteries are
used, re-adjustment of the low dis-
charge signal indicator is required.
The low discharge signal indi-
cator may only be adjusted by
an authorized Hako service
center.
5.4.3 Servicing the driving batteries
For information on servicing driving bat-
teries, refer to operating manual 88-60-
2556.
5.4.4 Removing the batteries
1. Park the vehicle on a level floor.
2. Switch off the vehicle by turning the
key switch.
3. Release the side locks (Fig. 10/4)
and open the empty recovery tank
(Fig. 10/5).
4. Disconnect the battery plug (Fig. 10/
2).
5. Remove the battery connection ca-
ble.
6. Remove the batteries.
5.4.5 Inserting the batteries
Due to a change in the center
of gravity, only approved bat-
teries may be installed at the
intended position.
1. Switch off the vehicle by turning the
key switch.
2. Release the side locks (Fig. 10/4)
and open the empty recovery tank
(Fig. 10/5).
3. Position the batteries in the battery
tray in accordance with the figure.
4. Connect the battery poles to the con-
nection cables in the accessories kit
according to the wiring diagram (Fig.
10/5). Pay attention they are firmly
fixed and grease the poles.
39
Hide quick links:
Advertisement
Table of Contents
