Step 3: Install The Safety Shield; Step 4: Connect System Power; Step 5: Optional Equipment Setup - Thermo Scientific Versette Brief User Manual

Step 3: Install the safety shield

1. Slide the blue safety shield assembly onto the system and attach with four supplied M5 x 10 mm
shoulder screws using a 3 mm hex wrench.
2. Lift the hood and attach the grounding strap from the stage to hood, as shown:
Inside view when properly installed

Step 4: Connect system power

1. Connect supplied power cable to the system and to a correctly installed line power outlet which
has a protective conductor, also called earth or ground.

Step 5: Optional equipment setup

1. If using a wash station and/or external fluid connections, refer to the Versette User Manual for
installation details.
Loosen the screw on outside, then attach
grounding strap to the inside with a screw,
lockwasher, and nut.
Outside view when properly installed
Warning! Ensure that the mains switch is in the
OFF (O) position. Never operate the instrument from a
power outlet that has no ground connection. Never
use a power supply cable other than the Thermo
Scientific power supply cable designed for your region.
8