Keysight E8267D User Manual page 75

Basic Operation
Configuring the RF Output
During swept RF output, the FREQUENCY and/or AMPLITUDE areas of the
NOTE
signal generator's display are deactivated, depending on what is being
swept. In this case, since frequency is being swept, nothing appears in the
FREQUENCY area of the display.
7. Press Frequency > Freq CW.
8. Press Freq Start.
In a frequency ramp sweep, the start frequency must be lower than the stop
NOTE
frequency.
9. Adjust the settings for Freq Center and Freq Span so that the frequency
Keysight E8357D/67D & E8663D PSG User's Guide
The current continuous wave frequency setting now controls the RF
output and ramp sweep is turned off.
The ramp sweep settings once again control the RF output and the CW
mode is turned off. Pressing any one of the softkeys Freq Start, Freq Stop,
Freq Center, or Freq Span activates a ramp sweep with the current
settings.
response of the device under test (DUT) is clearly seen on the 8757D
display.
Notice how adjusting these settings also changes the settings for the Freq
Start and Freq Stop softkeys. You may need to rescale the response on the
8757D for a more accurate evaluation of the amplitude.
page 62 shows an example of a bandpass filter response.
Figure 2-4 on
61