Keysight E8267D User Manual page 71

Basic Operation
Configuring the RF Output
1. Press Sweep Repeat Single Cont.
2. Press Sweep Type List Step.
3. Press Configure List Sweep.
4. Press More (1 of 2) > Load List From Step Sweep > Confirm Load From
To Edit List Sweep Points
1. Press Return > Sweep > Off.
2. Press Configure List Sweep.
3. Use the arrow keys to highlight the dwell time in row 1.
4. Press Ed it Item.
5. Press 100 > msec.
6. Using the arrow keys, highlight the frequency value in row 4.
7. Press Ed it Item > 545 > MHz.
8. Highlight any column in the point 7 row and press Insert Row.
Keysight E8357D/67D & E8663D PSG User's Guide
This toggles the sweep repeat from continuous to single. The SWEEP
annunciator is turned off. The sweep will not occur until it is triggered.
This toggles the sweep type from step to list.
This opens another menu displaying softkeys that you will use to create
the sweep points. The display shows the current list data. (When no list
has been previously created, the default list contains one point set to the
signal generator's maximum frequency, minimum amplitude, and a dwell
time of 2 ms.)
Step Data.
The points you defined in the step sweep are automatically loaded into the
list.
Turning the sweep off allows you to edit the list sweep points without
generating errors. If sweep remains on during editing, errors occur
whenever one or two point parameters (frequency, power, and dwell) are
undefined.
This returns you to the sweep list table.
The dwell time for point 1 becomes the active function.
This enters 100 ms as the new dwell time value for row 1. Note that the
next item in the table (in this case, the frequency value for point 2)
becomes highlighted after you press the terminator softkey.
This changes the frequency value in row 4 to 545 MHz.
This adds a new point between points 7 and 8. A copy of the point 7 row is
placed between points 7 and 8, creating a new point 8, and renumbering
the successive points.
57