To Edit The Multitone Setup Table - Keysight E8267D User Manual

Multitone Waveform Generator
Creating, Viewing, and Optimizing Multitone Waveforms
Figure 9-3

To Edit the Multitone Setup Table

This procedure builds upon the previous procedure.
1. Press Initialize Table > Number of Tones > 10 > Enter.
2. Press Done.
3. Highlight the value (On) in the State column for the tone in row 2.
4. Press Toggle State.
5. Highlight the value (0 dB) in the Power column for the tone in row 4.
6. Press Ed it Item > –10 > dB.
7. Highlight the value (0) in the Phase column for the tone in row 4.
8. Press Ed it Item > 123 > deg.
9. Press Apply Multitone.
Whenever a change is made to a setting while the multitone generator is
NOTE
operating (Multitone Off On set to On), you must apply the change by
pressing the Apply Multitone softkey before the updated waveform will be
generated. When you apply a change, the baseband generator creates a
multitone waveform using the new settings and replaces the existing
waveform in ARB memory.
Keysight E8357D/67D & E8663D PSG User's Guide
Multitone
Channels
Intermodulation
Distortion
255