Keysight E8267D User Manual page 309

Peripheral Devices
N5102A Digital Signal Interface Module
2. If the port configuration is parallel or parallel interleaved, using an IQ
3. Select the clocks per sample value to fit the test.
4. Press the Clock Source softkey.
5. Select the clock source.
The clock phase and clock skew may need to be adjusted each time the clock
NOTE
rate setting is changed. Refer to
Adjustments" on page
Keysight E8357D/67D & E8663D PSG User's Guide
806
signal type, press the
Clocks Per Sample softkey.
Notice that multiple clocks per sample can be selected. Some DACs
require the ability to clock multiple times for each sample; having a clocks
per sample value greater than one reduces the sample rate by a factor
equal to the selected number of clocks per sample. The sample rate is
viewed on the first-level and Data Setup softkey menus.
From this menu, select the clock signal source. With each selection, the
clock routing display in the signal generator clock setup menu will change
to reflect the current clock source. This will be indicated by a change in
the graphic.
If External or Device is Selected
Press the Clock Rate softkey and enter the clock rate of the externally
applied clock signal.
284.
This error is reported when the output FIFO is
overflowing in the
digital module. This error can be generated if an
external clock
or its reference is not set up properly, or if the
internal VCO is
unlocked.
Digital module output FIFO underflow
error; There are not enough samples
being produced for the current clock
rate. Verify that the digital module
clock is set up properly.
This error is reported when the output FIFO is
underflowing in the digital module. This error can
be generated if an external clock or its reference is
not set up properly, or if the internal VCO is
unlocked.
"Clock Timing for Phase and Skew
295