Hot-Plug Drive Blank - HP Apollo 4200 Gen9 Maintenance And Service Manual

Pull and hold the drive cage rail release latches, and then slide the front drive cages back into the
3.
chassis.
Install the air baffle.
4.
Install the access panel.
5.
Install the server into the rack.
6.
Power up the server.
7.

Hot-plug drive blank

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
If installed, remove the security bezel (on page 24).
1.
Remove the drive blank.
2.
To replace the LFF drive blank, slide the component into the bay until it clicks.
To prevent improper cooling and thermal damage, do not operate the server unless
DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 34