Enabling The Dedicated Ilo Management Module - HP Apollo 4200 Gen9 Maintenance And Service Manual

—
Two-bay SFF hot-plug rear drive cage removal
from the rear drive
Remove the dedicated iLO management module.
6.
To replace the component, reverse the removal procedure. After installing the new dedicated iLO
management module, enable the dedicated iLO connector
module" on page 114).

Enabling the dedicated iLO management module

The onboard NIC 1/shared iLO connector is set as the default system iLO connector. To enable the
dedicated iLO management module, use the iLO 4 Configuration Utility accessible within the HP UEFI System
Utilities.
For more information on the HP UEFI System Utilities, see the UEFI documentation on the HP website
(http://www.hp.com/go/ProLiantUEFI/docs).
cage" on page 26)
DRAFT - HP Confidential - DRAFT
("Hot-plug drive" on page 35,
("Enabling the dedicated iLO management
Removal and replacement procedures 114
"Remove a drive