Heatsink - HP Apollo 4200 Gen9 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
7.
Install the access panel.
8.
Install the server into the rack.
9.
Power up the server.
10.

Heatsink

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 27).
3.
Remove the access panel
4.
Remove the air baffle
5.
Remove the heatsink:
6.
Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
a.
Completely loosen all screws in the same sequence.
b.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Access panel" on page 36).
("Air baffle" on page 37).
DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 66