Sartorius ME215 Operating Instructions Manual page 68

Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing (NUM print; S ID),
you can also access the following
functions from this application:
Calibration/Adjustment
Press the Cal soft key
> See "Calibration, Adjustment and
Linearization" for further instructions
Example
Toggle the Display from Grams [g] (1st Unit) to Carats [ct] (2nd Unit)
Settings (changes in the factory settings required for this example):
Setup: Application parameters: Application 1: Toggle wt. units: Weight unit 2: Carats/ct
Step
1. Toggle back to the basic unit
( :Weight unit 1)
(
2. Change weight unit
to carats [ct]
( :Weight unit 2)
)
3. Change weight unit
to grams [g]
68
Toggling to the Next Application
Press d
> See the section on the
corresponding application program for
further instructions
Setup (Setting Parameters)
Press o
> See "Configuring the Balance" for
further instructions
Turning Off the Balance
Press e
> The balance shuts off
> The display goes blank, then standby or
off is displayed with backlighting
Press key(s) (or follow instructions)
c
ct soft key
g soft key
Display/Output
Max 210 g
0%
F 12048326
S
TOGGLE UNITS:
Cal
Max 105
0%
F 60241630
TOGGLE UNITS:
Cal
d=0.01mg
100%
$
L
a
g
S
s
T
ct
d=----
100%
%
L
a
S
ct
s
T
g