If You Replace The Double Feeding Sensor; Setting Double Feeding Sensor Threshold - Brother ADS-2000 Service Manual

3. IF YOU REPLACE THE DOUBLE FEEDING
SENSOR
<What to do after replacement>

• Setting double feeding sensor threshold

• Checking double feeding function
What you need to prepare
(1) Document for double feeding sensor threshold setting
(2) Document for double feeding check
(3) Double feeding sensor threshold setting tool (BrADSmt1.exe)
Copy this file into the temporary folder created on the C drive.
3.1 Setting Double Feeding Sensor Threshold
(1) Press and hold the [Stop] and [Scan to USB] buttons, and plug the AC cord into the
outlet. Check that the Power LED and the Error LED are lit, and release these two
buttons.
(2) Press the [Stop], [Scan to USB], [Scan to PC], and [Stop] buttons in this order.
The Scan to USB LED and the Scan to PC LED light.
(3) Press the [Scan to PC] button. The Scan to USB LED and the Scan to PC LED go out.
(4) Turn ON the power switch of the computer.
(5) Connect the computer to the machine with the USB cable.
Note:
• To use remote check mode, the computer needs to be connected to the machine
with the USB cable and the power switch of the computer must be turned ON before
proceeding to step 6.
(6) Press and hold the [Stop] button until the Power LED lights.
(7) Double-click "BrADSmt1.exe" that was copied into the temporary folder to start it.
(8) Select the model name in the [Select model:] box, and click the [Start] button. The
double feeding sensor threshold is set.
4-9
Confidential