Brother ADS-2000 Service Manual page 79

(14) Release the hook, then remove the document detection actuator and the document
detection actuator spring.
(15) Remove the document detection actuator spring from the document detection actuator.
(16) Remove the two taptite bind B M3x10 screws. Then release the earth harness (GR) and
the pinch roller support plate from the upper chute to release the earth harness (GR) from
the securing fixtures.
(17) Remove the document scanning position actuator and the document scanning position
actuator spring from the upper chute.
(18) Remove the document scanning position actuator spring from the document scanning
position actuator.
Earth harness (GR)
Pinch roller support plate
Document scanning
position actuator
Upper chute
Document scanning
position actuator
HARNESS ROUTING: Refer to
Assembling Note:
• Attach the document detection actuator spring on the position described in the
illustration above.
• Attach the document scanning position actuator spring on the position described in the
illustration above.
Taptite bind B M3x10
Document scanning
position actuator spring
Fig. 3-25
"2. Panel PCB ASSY".
3-27
Document scanning
position actuator spring
Document detection actuator
Document detection
actuator spring
Hook
Document
detection actuator
Document detection
actuator spring
Confidential