Rail Installation - Harmar Mobility Pinnacle SL600 Installation And Service Manual

B. RAIL INSTALLATION
Step 1: Open the rail box and remove the contents.
Step 2: Position the bottom rail (the rail with end plate attached) directly on the stairs
with the end plate towards the bottom of the stairs and the plastic rack facing up. Place
an object that measures between 3/4" and 1" between end plate and the floor.
tiP!
Step 3: Position the two ends of the track close together. Locate and connect the plug on the ends of the two
charger harnesses inside the two track pieces.
Step 4: With the plastic rack facing up, slide the top rail into the bottom rail and guide them together using the
pre-installed pins. Gently tap the top rail if necessary to get them close together. Be cautious not to pinch the
charger harness.
Step 5: Install two (2) joint fasteners and firmly tighten with 3/16" Allen wrench. Then
slide rack pieces down to cover joint.
Step 6: Turn over joined rails and install the remaining two (2) joint fasteners and
firmly tighten with 3/16" Allen wrench. Then slide rack pieces down to cover joint.
Use the chair box or another heavy object, like a toolbox, at the bottom to prevent the
rail from sliding down the stairs.
installation Procedures table of Contents