Rail Installation - Harmar Mobility Pinnacle Series Installation Manual

B. RAIL INSTALLATION
1. Open the rail box and remove the contents.
2. Position the bottom rail (the rail with end plate
attached) directly on the stairs with the end plate
towards the bottom of the stairs and the plastic
rack facing up. Place an object that measures 1/2"
between end plate and the floor. [Figure 5-1 and 5-2]
Use the chair box, or another heavy object, like a toolbox, at
the bottom to prevent the rail from sliding down the stairs.
TIP
3. Position the two ends of the rail close together.
Locate and connect the plug on the ends of the two
power harnesses inside the two rail pieces. [Figure 5-3]
4. With the plastic rack facing up, slide the top
rail into the bottom rail and guide them together
using the pre-installed pins. Gently tap the top rail
if necessary to get them close together. Be cautious
not to pinch the power harness. [Figure 5-4]
5. Install two (2) joint fasteners and firmly tighten
with 3/16" Allen wrench. Then slide rack pieces
down to cover joint. [Figure5-5]
6. Turn over joined rails and install the remaining
two (2) joint fasteners and firmly tighten with 3/16"
Allen wrench. [Figure 5-6]
7. Install rail brackets with label facing the wall by
loosening the screws and snapping each bracket
edge into the slot, or slide the brackets on from the
top of the rail. [Figure 5-7]
The brackets are tightened from one side only. It is important
that the bracket be installed with the nut side facing the wall
so when the rail is turned over to its correct orientation the
TIP
screws will be accessible.
72618 P/N: 630-00100 Rev E
INSTALLATION PROCEDURES
Figure 5-1
Pinnacle SL300
Figure 5-3
Figure 5-5
Figure 5-7
SL300 • Pinnacle Stair Lift Installation Manual
Figure 5-2
Figure 5-4
Figure 5-6
5