Harmar Mobility Pinnacle SL600 Installation And Service Manual page 25

STEP 25: Push the ends of the gas strut onto the ball-studs.
STEP 27: Unfold the rail so it is straight.
1/4" gap
STEP 29: Tighten the two nuts with a 1/2" socket wrench, ref. tighten to about 10 ft-lbs.
STEP 24: Make sure the wire-retainers aren't in the gas strut, then snap the gas strut
onto the ball ends. You have to compress the strut a little to fit both ends.
STEP 26: Put the wire-retainers into both ends of the gas strut.
STEP 28: Position bottom bracket so there is about a 1/4" gap between the shoulder
bolt and the forward end of the slot.
STEP 30: Now begin the changes necessary for the Pinnacle unit. The changes are
shown here on the bar chassis for clarity here.
Use a #2 (medium size) Phillips screwdriver to remove the screw toward the up-side of
the Pinnacle side-plate.
folding rail Conversion