Footrest And Seat Installation - Harmar Mobility Pinnacle SL600 Installation And Service Manual

Step 6: Install one of the rack pre-compression screws in the threaded hole in the top
plate of the rail, and tighten it as firmly as possible by hand with a 5/32" Allen wrench.
There are three (3) kinds of pre-compression screws:
1. 1/2" for tracks under 6'
2. 3/4" for tracks between 6' and 12'
3. 1" for tracks over 12'
Step 7: Plug in the battery charger at either end of the rail, depending on
the closest or most convenient location of a wall power supply. Minimize
wire length and intrusion.
E. FOOTREST & SEAT INSTALLATION
Step 1: Remove footrest from box and use the installation switch to drive the
chassis downward to a position about 6" clear of the floor. This will provide a
safe area to install and adjust the footrest. Do not drive the unit into bottom stop.
Step 2: Turn the red "ON/OFF" switch located on the top of the chassis to the
"OFF" position (0).
Step 3: Position the footrest onto the two (2) seat-leveling bolts on the
outside of the chassis by aligning the large opening at the slot ends of the footrest.
Step 4: Ensure the footrest is fully engaged.
table of Contents
installation Procedures