Harmar Mobility Pinnacle SL600 Installation And Service Manual page 11

Step 11: The armrest control is factory set for right-hand
operation. If the user prefers to operate the armrest
controls with their left hand, loosen the single screw on the
underside of each armrest and slide each armrest upwards.
Disconnect the plug on the armrest control, switch the
armrests, and reconnect the plug. Replace armrests and
tighten screws.
Step 12: If the lift is equipped with the optional key lock, ensure that the key
switch on the armrest control is in the locked position (with the key in the vertical
position)
Step 13: Turn the red "ON/OFF" switch located on the top of the chassis to the
"ON" (I) position. You should hear a single beep and the LED indicator light on the
armrest control should cycle through a test sequence, showing red, yellow and green
respectively. If any of the system controls or safety sensors are engaged the LED
indicator light will turn to yellow.
Step 14: If the LED indicator light is not green, check the safety senors:
1. Seat swivel sensor (seat should be in the locked position)
2. Footrest lower sensor (check by pushing in on the safety pan on the footrest)
3. Upper foot pan safety sensor (check by pushing on the safety pan on the footrest).
4. Front foot pan safety sensor (check by pushing on the safety pan on the footrest).
5. Uphill safety sensor (ensure nothing is blocking upward passage)
6. Downhill safety sensor (ensure nothing is blocking downward passage)
If the LED indicator light is still not green after testing sensors, turn the unit off and recheck all wire plugs. Turn
the unit on again and recheck the LED indicator light cycle. When the LED indicator light remains green the lift is
ready to operate.
installation Procedures table of Contents