Harmar Mobility Pinnacle SL600 Installation And Service Manual page 26

folding rail Conversion
STEP 31: Use a 5/16" Allen wrench to remove the two large bolts that hold the
side-plate onto the Pinnacle unit.
STEP 33: Reinstall both of the large Allen bolts in the unit and tighten them.
STEP 35: Use a #2 Phillips screwdriver to remove the lower safety switch bumper
from the Pinnacle unit. It has four screws.
reinstall it. The necessary holes should already be in the safety bumper.
STEP 32: Remove the side plate.
STEP 34: Remove the two large bolts from the other side and install the side-plate.
Align and start the Phillips screw and the two large bolts before you tighten any of
them.
STEP 36: On the back side of the bumper, remove the two screws that hold the
angled metal arm. This arm is to prevent the Pinnacle from being able to travel
down if the rail is already folded down.
STEP 37: Flip the arm to the other side and